. .

Thread: Mainul

  1. 01-10-2010 #1
    Mainul's Avatar
    Lives in Dhaka, Bangladesh.
    Mainul
    Last Activity: 12-04-2013 Has been a member for 9-10 years. Has a total post count of 1.
    Hello,

    I have entered into the forum with lot of expectation to learn from well experienced members here. Presently I am trying to find out a good USB to Parallel converter. It should have x,y and z controlls with step, direction and enable signals for each stepper motor.
    Reply With Quote Reply With Quote
  2. 01-10-2010 #2
    irving2008's Avatar
    Lives in NW London, gateway to A1 & M1, United Kingdom.
    irving2008
    Last Activity: 17-03-2017 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 2,849. Received thanks 179 times, giving thanks to others 5 times. Referred 6 members to the community.
    Hi Mainul and welcome to the site. If you are looking for a generic converter to use with a standard stepper controller I don't think there are many that work reliably because of the timing issues. Most of the USB interfaces for CNC use are for use with proprietary software.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules