1. #1
    Greetings. I've been designing / fabricating automation equipment for many years (40), and continually like getting the different perspectives and approaches to problem solving from the many creative people in the machining field. Though I have been machining for many years as well, I don't consider myself a machinist in the true snese. I have a small shop, lathe, miller, grinder, saw and a fair amount of tooling, some made, some purchased, and have been self-employed for about 22 years. All of my equipment is the older, manual style. I do a fair amount of gunsmithing, too. Besides learning from the talents and skills of others here, I hope to be able to contribute some of my experiences in the designing, machining and fabrication area. I'm looking forward to this experience.

  2. Hi,

    Welcome to the site, your membership has been approved and you now have full access.

    Sorry for the delay,


Similar Threads

  1. Training / Self learning
    By manofgresley in forum Programmers Corner
    Replies: 3
    Last Post: 27-02-2014, 12:25 PM
  2. NEW MEMBER: Learning with MYCNCUK
    By Goran in forum New Member Introductions
    Replies: 1
    Last Post: 10-12-2010, 05:08 PM
  3. NEW MEMBER: New Member in southwest Virginia, USA!
    By ArdenHTF in forum New Member Introductions
    Replies: 1
    Last Post: 04-11-2010, 09:54 AM
  4. NEW MEMBER: Hello from Virginia, USA
    By RichKuzmack in forum New Member Introductions
    Replies: 1
    Last Post: 24-10-2010, 06:01 PM
  5. TB6560 > Timer > GMFC
    By Theo in forum Motor Drivers & Controllers
    Replies: 0
    Last Post: 17-10-2010, 05:59 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts