Thread: Sieg X3 backlash...
Ok, I'm a complete newb learning on a manual Sieg X3. Today I'm trying to figure out how I can reduce backlash. I have yet to strip it down and clean it but looking at the prep guide this will take me a long time...
Measured backlash is: X: 0.26mm, Y: 0.2mm, Z: 0.09mm.
Can this mill be adjusted to reduce backlash, and if so any pointers of how to actually do it would be greatly appreciated!
By Minnican in forum Machine DiscussionReplies: 19Last Post: 06-03-2011, 07:59 PM
By h4ppy-chris in forum General DiscussionReplies: 9Last Post: 29-01-2011, 12:11 PM
By fasteddy in forum Gantry/Router Machines & BuildingReplies: 3Last Post: 18-08-2010, 04:04 PM
By Cret in forum Milling Machines, Builds & ConversionsReplies: 10Last Post: 08-09-2009, 06:18 AM
By cweeks in forum Milling Machines, Builds & ConversionsReplies: 0Last Post: 28-05-2009, 05:41 PM