1. #1
    Hi,

    I have a small chinese miller (x travel 400mm, y 150mm, z 85mm) that I converted some years ago to CNC using unipolar Compucut system plus ballscrews. I am currently converting to bipolar using DIYCNC System4, Mach3 plus Kflop usb interface.

    I am considering building a gantry router with a bed size of about 1200mm x 600mm.

    Searching this forum has proved very useful in solving any problems that I have had.

    Cheers
    Rob

  2. #2
    Hi,

    Welcome to the site, your membership has been approved and you now have full access.

    Please post your questions in the correct forums for the best assistance.

    Lee
    .Me

Similar Threads

  1. NEW MEMBER: My introduction
    By Ashish in forum New Member Introductions
    Replies: 0
    Last Post: 29-11-2011, 05:57 AM
  2. NEW MEMBER: Introduction
    By mrpeja in forum New Member Introductions
    Replies: 1
    Last Post: 23-12-2010, 04:59 PM
  3. NEW MEMBER: Hello from Newcastle upon Tyne
    By eastgate in forum New Member Introductions
    Replies: 1
    Last Post: 15-12-2010, 10:43 AM
  4. NEW MEMBER: introduction
    By john696d in forum New Member Introductions
    Replies: 1
    Last Post: 08-12-2010, 01:38 PM
  5. NEW MEMBER: Introduction
    By madd in forum New Member Introductions
    Replies: 1
    Last Post: 04-12-2010, 01:31 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •