1. #1
    Hi, friends!

    CNC and robotics has fascinate me for all my life. My main ocupation is in electronics and automation, so cnc is not far away...
    After long period of "sleep mode", last month I put back in operation my small mill (engraver), 400x300x70mm of travel, by using EMC Linux. EMC has gone long way till I used it last time (it was on RedHat distribution of Linux, not shure about release), and I was able to run the machine after few hours of playing with software. Great stuff, thank's to all EMC developers!
    So, that's it, I think this forum will give me tons of ideas how to proceed.

    Bye !


  2. Hi,

    Welcome to the site, your membership has been approved and you now have full access.

    Please post your questions in the correct forums for the best assistance.


Similar Threads

  1. NEW MEMBER: Hello from Slovenia!
    By PCP in forum New Member Introductions
    Replies: 1
    Last Post: 07-11-2010, 07:57 PM
  2. NEW MEMBER: Hello from Celje, Slovenia
    By deeejo in forum New Member Introductions
    Replies: 1
    Last Post: 15-10-2010, 05:47 PM
  3. NEW MEMBER: Hello from Slovenia
    By dominikgruden in forum New Member Introductions
    Replies: 2
    Last Post: 29-09-2010, 02:53 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts