1. #1
    Hello all,

    I'm looking to build an interface between some cheap Chinese scales and a PC to use as a DRO. USB would be nice but I would settle for serial connections. I'm a VB programmer so once I get it on the PC I should be able to get the rest going.

    If anyone has the interface built and needs VB programming to run it let me know and I'll try to work out a deal.

    Any help would be appreciated. My mill is nearly impossible to read using the factory dials and I need a good DRO that I can count on.

  2. #2
    Hi,

    Welcome to the site, your membership has been approved and you now have full access.

    Please post your questions in the correct forums for the best assistance.

    Lee
    .Me


  3. The Following User Says Thank You to BillTodd For This Useful Post:


  4. #4
    That will get me started. Thanks again for the info.

Similar Threads

  1. USB TO Parallel Port DIY Interface
    By Lee Roberts in forum Electronic Project Building
    Replies: 40
    Last Post: 04-11-2016, 09:38 PM
  2. CIB Industrial Control Interface
    By antsals in forum Motor Drivers & Controllers
    Replies: 8
    Last Post: 20-04-2011, 11:02 AM
  3. MPG Jog interface for Mach3
    By HiltonSteve in forum Electronic Project Building
    Replies: 44
    Last Post: 24-09-2009, 07:49 PM
  4. HID interface for remote control of Mach3
    By Smiler in forum Electronic Project Building
    Replies: 0
    Last Post: 10-05-2009, 12:59 PM
  5. Cheap for hacking
    By Robin Hewitt in forum General Discussion
    Replies: 12
    Last Post: 21-11-2008, 01:30 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •