The time has come to sell my 4 Axis TB6560 stepper motor driver board, as I have now reached the limits of this board, and now upgrading.
I have been running this board at 28volts, and is as far as I am willing to push it.
On my current setup I get a feed rate of around 500mm/min, using ASTROSYN MY103H702 1Nm Stepper Motors, and TR10x2 trapezoidal thread.
These boards are still selling on eBay for around £50.
Open to sensible offers, postage will be around £5 for UK mainland.
If I don't get any interest in the next few days, I will put this up on ebay.
Last edited by Mad Professor; 04-01-2011 at 02:59 PM."If first you don't succeed, redefine success"
Think you'll find the limiting factor is the motor not the board - these are high inductance motors. I have the same motors and even on 36v can't get more than 300rpm (600mm/min on TR10x2) on my small machine. If you want more speed its the motors you need to change not the board...
By Mad Professor in forum Motor Drivers & ControllersReplies: 128Last Post: 24-01-2016, 11:12 PM
By craynerd in forum Motor Drivers & ControllersReplies: 1Last Post: 16-03-2014, 06:29 PM
By TommeyReed in forum Motor Drivers & ControllersReplies: 2Last Post: 06-03-2012, 05:01 PM
By irving2008 in forum Motor Drivers & ControllersReplies: 13Last Post: 07-04-2010, 03:48 PM
By Dan Brown in forum Motor Drivers & ControllersReplies: 5Last Post: 06-01-2010, 09:37 PM