When I jog my Y axis from end to end there is a patch in the middle where the table/screw make a grinding noise but it still travels and motor is not loosing steps. Its the same area each time but it doesn't make noise to the same extend on its way back. What needs adjusting?
Have you put any lube on it ?.Me
its dripping with lube, plus this happens only over a few centimeters on the Y.
Humm i dont really know what that could be then sorry..Me
Isnt a "dovetail" a type of wood joint?.Me
yes, but exactly the same shape is used as an accurate slide mechanism. I suppose he should have said 'slacken the gibs' as they are the plates that control the loading on the dovetail... see pic
More info on your machine will definitely get people going in the right direction.
This question is like asking
" I have a blue car here so will these wheels fit on it? "
Not a lot of info.
Is it recirculating ballscrews?
What type of drives are you using ?
Do you have ballscrew lead screws or acme thread with anti-backlash nuts
You need to give a lot more info so we can correctly diagnose the problem
By deisel in forum Milling Machines, Builds & ConversionsReplies: 2Last Post: 19-02-2014, 09:28 AM
CONVERSION: Sieg Super X3 conversionBy Sooty in forum Conversion Build LogsReplies: 0Last Post: 06-03-2013, 01:29 PM
By ecat in forum Milling Machines, Builds & ConversionsReplies: 7Last Post: 04-10-2010, 11:07 PM
By Gary in forum Milling Machines, Builds & ConversionsReplies: 2Last Post: 25-10-2008, 09:58 PM
By bruce_miranda in forum Sieg Milling MachinesReplies: 12Last Post: 19-09-2008, 12:43 PM