. .
  1. #1
    Hi

    I'd like to introduce myself to the forum.

    I'm based in Boston in Lincolnshire and been working as a nurse for the last 20 years. I've now reached a point in my life where I want to start working for myself and have seen a CNC router in use in a successful home business in the past. I was truly suprised at what these machines can produce and I figure that if one person can be successful then there's nothing but hard work stopping me from doing the same.

    However, I have no experience in using CNC machines or any experience of CAD software so I thought this would be the place to start for helpful advice to get through the myriad of problems I will encounter.

    I'm looking forward to being accepted as part of this community, or am I being presumptuous!

    Regards.
    Last edited by irving2008; 09-02-2011 at 11:08 AM.

  2. Hi there and welcome to the site. There's plenty of experience and help here to guide you. Obviously running a CNC for business is different from running it for a hobby, not least because reliability and downtime become important. But a little ingenuity and a lot of self-belief go a long way, and we have several members who do run businesses based on CNC. So ask away in the appropriate forums and good luck!

  3. The Following User Says Thank You to irving2008 For This Useful Post:


  4. #3
    Thank you very much!

  5. #4
    hello and welcome,

    enjoy the forum

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. NEW MEMBER: New to the forum & cnc
    By elvis in forum New Member Introductions
    Replies: 0
    Last Post: 28-01-2013, 12:52 AM
  2. NEW MEMBER: New to forum.
    By N Holmes in forum New Member Introductions
    Replies: 0
    Last Post: 19-01-2013, 10:02 AM
  3. NEW MEMBER: New Member from Lincolnshire
    By Grabo in forum New Member Introductions
    Replies: 1
    Last Post: 11-12-2010, 08:44 PM
  4. NEW MEMBER: Hello Forum
    By MickG in forum New Member Introductions
    Replies: 2
    Last Post: 22-08-2010, 10:04 PM
  5. NEW MEMBER: hello forum
    By quicksnail in forum New Member Introductions
    Replies: 1
    Last Post: 22-08-2010, 10:24 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •