I have the following that I am open to any offers on.... Maybe a 4th axis??
The Brushless motor is as follows:
With the following Maxon Parts:
Motor EC45 136209
Gearbox GP42 26:1
Encoder HEDL 9140 (500ppr - don't forget edge multiplication in the controller)
EPOS 70/10 position controller (This can be set up to do step and direction, with a RS232 Tuning interface etc)
Maxon shunt regulator (235811) - Protects the power supply from over voltage when Rapid moving.
As I say open to offers.... Any questions please ask
Sold for £60
By rnr107 in forum Spindles & Drive MotorsReplies: 2Last Post: 23-04-2014, 03:14 PM
By DigiSoft in forum Spindles & Drive MotorsReplies: 5Last Post: 17-09-2013, 12:17 AM
By spluppit in forum Motor Drivers & ControllersReplies: 0Last Post: 25-04-2013, 03:02 PM
By gbar in forum Stepper & Servo MotorsReplies: 4Last Post: 11-05-2012, 12:12 PM
By clockman in forum Woodworking Project ShowcaseReplies: 9Last Post: 30-01-2011, 11:39 PM