Thread: ATC querry
Threaded View
-
29-06-2011 #1
I have a 1989 takasawa mac v2e vmc, I recently had issues with air flow, being that my compressor wasnt big enough. I have got round this but I have also found something that could be in need of attention. When the machine is in the middle of a tool change and the pull stud clamp is open, it exhausts a hell of a lot of air out the back through the small filter, is this normal? can it be adjusted? This is the main cause of my compressor struggling to keep up, if I could lower the amount of air it wastes then it would ease the job of the compressor.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks