First project is to convert an X-Y table to Mach3 control. The primary aim here is to learn about the Mach3 software.

So we have on the table (from Zapp):
  • Stepper Motor: SY60STH88-300*BF (qty 2)
  • Drivers: PM542 (qty 2)
  • Power Supply: EP002G1 (qty 1)
  • Breakout Board: ZP5A-Int 5


Now at this point we would really appreciate if someone would kindly assist by providing a wiring diagram for all of the above.

(Of course, this would be a good point for someone to suggest/recommend an alternative to Mach3)


Many thanks

Karl