. .
  1. 15-07-2011 #1
    Swarfing's Avatar
    Lives in Swindon, United Kingdom.
    Swarfing
    Last Activity: 08-09-2018 Has been a member for 9-10 years. Has a total post count of 1,001. Received thanks 51 times, giving thanks to others 3 times. Is a beta tester for Machinists Network features.
    Guys

    Just fired up for first time with the above, using the charge pump on pin1 (no matter if inverted) has the drives in an on state immediate. If i switch on in EMC2 they go off. Using the force or changing the enable pins does not work either? Any ideas?:sad:
    If the nagging gets really bad......Get a bigger shed:naughty:
    Reply With Quote Reply With Quote
  2. 15-07-2011 #2
    Swarfing's Avatar
    Lives in Swindon, United Kingdom.
    Swarfing
    Last Activity: 08-09-2018 Has been a member for 9-10 years. Has a total post count of 1,001. Received thanks 51 times, giving thanks to others 3 times. Is a beta tester for Machinists Network features.
    Now sorted, just had some grounds in the wrong place.....Will get some photos up and a vid once finished playing
    If the nagging gets really bad......Get a bigger shed:naughty:
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. EMC2 home/limit switches... only acting as limit?
    By vputz in forum LinuxCNC (EMC)
    Replies: 4
    Last Post: 15-10-2014, 09:51 AM
  2. EMC2 or USBCNC?
    By icedfusion in forum Machine Control Software
    Replies: 9
    Last Post: 12-02-2013, 04:04 AM
  3. g code created for M3, can it be used with EMC2
    By deannos in forum Programmers Corner
    Replies: 3
    Last Post: 27-08-2012, 08:48 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules