1. #1
    Kai's Avatar
    Lives in Hull, United Kingdom. Last Activity: 28-04-2016 Has been a member for 6-7 years. Has a total post count of 72.
    A couple of people have asked me if I can do pictures over the last few weeks.
    So today I had a look round and there is a lot of software out there to do the job.
    Has anyone been down the same route and if so whats your views on the stuff thats out there.

  2. #2
    Take a look at Photo VCarve from Vectric, and try the demo
    John S -

Similar Threads

  1. send pictures via PM
    By deisel in forum General Discussion
    Replies: 1
    Last Post: 27-06-2013, 09:10 PM
  2. M542 problems see pictures
    By ciaranconlon in forum Motor Drivers & Controllers
    Replies: 18
    Last Post: 08-01-2013, 07:37 PM
  3. pictures of ballscrews??
    By wilfy in forum Lead Screws, Nuts & Supports
    Replies: 2
    Last Post: 28-10-2012, 08:09 PM
  4. Finding pictures and viewing the albums of a member ?
    By WandrinAndy in forum General Discussion
    Replies: 3
    Last Post: 16-10-2012, 02:29 PM
  5. Halftone CNC Pictures
    By Mad Professor in forum General Discussion
    Replies: 3
    Last Post: 01-09-2011, 10:40 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts