Page 3 of 3 FirstFirst 123
  1. #21
    New board and driver on its way (Gary at Zapp)... Holding breath in anticipation...!

  2. #22
    do you have any hair left ??


  3. #23
    Thanks all for help and advice...!!!
    No hair left James, just been told that it is genetic anyways, am currently trying to comb my eyebrows back over my forehead..!

    ALL WORKING NOW...!!! New board (Uniport 2) and driver (PM542).. After a teeth gnashing week, it is finally up and running... Gotta fine tune it all and fit limit switches, but wow, more funkyness than I can handle..


  4. #24
    hamlet cigars come to mind LOL

    glad you are sorted out


Page 3 of 3 FirstFirst 123

Similar Threads

  1. Machine Slow on Curves
    By swisscheese in forum Computer Software
    Replies: 31
    Last Post: 11-04-2014, 11:49 PM
  2. x-axis on Orac losing direction
    By asto in forum Motor Drivers & Controllers
    Replies: 3
    Last Post: 29-03-2013, 12:22 AM
  3. Forum Slow
    By pcstru in forum General Discussion
    Replies: 3
    Last Post: 27-01-2011, 02:54 PM
  4. Heelp! Dual axis steppers.. Losing steps.. Pulling hair out..!
    By fasteddy in forum Motor Drivers & Controllers
    Replies: 9
    Last Post: 14-05-2010, 01:32 PM
  5. stepper speed very slow
    By jonm in forum Stepper & Servo Motors
    Replies: 17
    Last Post: 01-11-2009, 11:39 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts