Thread: Diy Brushless Spindle
Threaded View
-
16-05-2012 #11
Far better than mine...wow has it been that long since I last looked at this....been too busy spending money on RC helis.
Bought a small boring bar and today in lunch bored the inside of the bearing holder out. Tomorrow will face off (parting tool not big enough) the part to the correct dims. Then just need enough Bellville washers to fill a 12mm gap...that offer of some washers still on Mark? ;)
Last bit is the cap then fit it all together...will take pics later!
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Denford router - Brushed router too brushless spindle - Help and advice please
By Tom B in forum Brushless Spindles & MotorsReplies: 4Last Post: 16-05-2016, 09:13 AM -
All-In-One Brushless Servo System
By Gytis in forum Stepper & Servo MotorsReplies: 0Last Post: 22-12-2015, 10:21 PM -
DIY Brushless spindle
By booski in forum Brushless Spindles & MotorsReplies: 2Last Post: 30-10-2013, 09:36 AM -
Using RC Brushless motors as spindle
By Jonathan in forum Brushless Spindles & MotorsReplies: 30Last Post: 20-12-2012, 08:51 PM -
Mach 3 control of DC Brushless motor?
By templecorran in forum Artsoft Mach (3 & 4)Replies: 15Last Post: 18-11-2010, 04:20 PM
Bookmarks