. .
Page 19 of 19 FirstFirst ... 9171819
  1. #181
    Hi all
    would this be any good as the motor, it has 10mm shaft and 200kv. I found a spindle that is 10mm URL="https://www.amazon.co.uk/dp/B07Q7473NH/?coliid=I1PB48BH2P8JSU&colid=1WM4D42BOQDI4&psc=1&r ef_=lv_ov_lig_dp_it"]https://www.amazon.co.uk/dp/B07Q7473NH/?coliid=I1PB48BH2P8JSU&colid=1WM4D42BOQDI4&psc=1&r ef_=lv_ov_lig_dp_it[/URL]
    any other good ones around
    Ta D

  2. #182
    ...I know it has been 10 years since the thread started... just wondering if somebody could make me one like Mark's with double bearing ?
    I fancy doing a small drill press like this one -> https://www.youtube.com/watch?v=T-ieUwOoqgw
    This will be used for drill wood and occasionally acrylic/ aluminium so maybe maximum of 4000 rpm.

Page 19 of 19 FirstFirst ... 9171819

Thread Information

Users Browsing this Thread

There are currently 7 users browsing this thread. (0 members and 7 guests)

Similar Threads

  1. Replies: 4
    Last Post: 16-05-2016, 08:13 AM
  2. All-In-One Brushless Servo System
    By Gytis in forum Stepper & Servo Motors
    Replies: 0
    Last Post: 22-12-2015, 09:21 PM
  3. DIY Brushless spindle
    By booski in forum Brushless Spindles & Motors
    Replies: 2
    Last Post: 30-10-2013, 08:36 AM
  4. Using RC Brushless motors as spindle
    By Jonathan in forum Brushless Spindles & Motors
    Replies: 30
    Last Post: 20-12-2012, 07:51 PM
  5. Mach 3 control of DC Brushless motor?
    By templecorran in forum Artsoft Mach (3 & 4)
    Replies: 15
    Last Post: 18-11-2010, 03:20 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •