. .
  1. #1
    hi all, ive just registered to the forum

    i do a little machining with work but nothing huge

    recently a bought a job lot off tools, i knew what a lot of it was but im having trouble with a final bit

    i think its a quick release collet tapping set up but im not entirely sure



    the markings are as follows:

    large main part/chuck

    bison s3
    mt4-c
    m14-m33

    the 3 collet sets

    m22 16x12.5
    m24 18x14.5
    m27 20x16

    ive googled it to to death but drawn a blank

    thank you in advance and i hope someone can shed some light

  2. #2
    Correct.
    MT4 taper with a capacity of M14 to M33 and the three tap holders are for M22, M24 and M27 possibly a tad to big for 6BA

    See here.

    http://www.machine-tapping.co.uk/tap...ap-collet.html
    John S -

  3. #3
    brilliant, thanks for the quick response:tup:

Thread Information

Users Browsing this Thread

There are currently 2 users browsing this thread. (0 members and 2 guests)

Similar Threads

  1. Newbie computer hardware question
    By chris in forum Computer Hardware
    Replies: 4
    Last Post: 16-01-2014, 05:12 PM
  2. NEW MEMBER: Newbie - question on bit types
    By Steven W in forum New Member Introductions
    Replies: 2
    Last Post: 16-05-2013, 12:06 PM
  3. FK12 BEARING, tighten on lead screw first - newbie question?.
    By Mark Snape in forum Lead Screws, Nuts & Supports
    Replies: 4
    Last Post: 08-03-2012, 10:59 AM
  4. What tool would you use for this?
    By Kai in forum Tool & Tooling Technology
    Replies: 1
    Last Post: 21-03-2011, 06:08 PM
  5. Newbie Question ...
    By Wobblybootie in forum General Discussion
    Replies: 1
    Last Post: 03-12-2009, 05:32 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •