1. #1
    Hi all, im looking for somebody to make me one of these if possible...

    to fit a 6mm collet for the sherline


    Thank you


  2. #2
    I can make you one of those easily enough - though I would machine it all without taking out of the chuck and turning round as that introduces runout. Make the nylon part first, oversize, then the steel ... push the nylon bit on then skim that and the rest to get it all concentric.

    It would be better to have the end a larger diameter than the rest as otherwise any burrs on the part you're probing will touch first, making it less accurate.

  3. #3
    That sounds very good.. could you pm me cast mate on this if you can


Similar Threads

  1. New cheap touch probe of fleabay
    By Robin Hewitt in forum Probing, Digitizing & Scaning
    Replies: 17
    Last Post: 19-08-2015, 08:36 AM
  2. Touch Probe Project
    By Washout in forum Tool & Tooling Technology
    Replies: 2
    Last Post: 20-11-2013, 11:59 AM
  3. Touch probe stylus - where to buy?
    By Mad Professor in forum Marketplace Discussion
    Replies: 3
    Last Post: 05-08-2013, 06:07 PM
  4. Touch Probe
    By luke11cnc in forum Probing, Digitizing & Scaning
    Replies: 28
    Last Post: 31-01-2012, 12:16 AM
  5. Touch Screen and Mach3
    By GeoffV in forum Artsoft Mach
    Replies: 6
    Last Post: 03-10-2010, 06:50 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts