Thread: wiring the drivers to the BOB
Threaded View
-
26-11-2011 #1
Started wiring up the electronics and i have used some screened cable to connect the BOB to the drivers. But i haven't seperated the individual wires, they are still incased with the sheilding etc. Would they be ok like this or would it be better to use the individual wires stripped of the shielding
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Help Make 1st Step - Wiring Up Drivers to Motor and Arduino
By Treemonkey in forum General ElectronicsReplies: 10Last Post: 25-04-2013, 05:47 PM -
Help wiring M60STH88-3008DF Steppers Motors to 752 Drivers
By Mad Professor in forum Stepper & Servo MotorsReplies: 12Last Post: 01-09-2011, 10:09 AM -
Has anyone used these steppers or drivers?
By Jonathan in forum Stepper & Servo MotorsReplies: 2Last Post: 24-03-2011, 02:24 PM -
Gecko drivers
By kingfisher in forum Motor Drivers & ControllersReplies: 0Last Post: 10-10-2009, 08:34 PM -
Steppers and drivers
By Davidh in forum Motor Drivers & ControllersReplies: 3Last Post: 12-06-2009, 05:59 PM
Bookmarks