1. #1
    Apart from EMC2 are there any other free controllers, don't want to pay for Mach3, well not yet anyway. Tried EMC2 but for some reason won't run on my PC.

  2. #2
    What happened when you tried to run EMC2?

  3. #3
    Quote Originally Posted by Jonathan View Post
    What happened when you tried to run EMC2?
    Wouldn't run, error log said it couldn't find a "Lapic" on the pc. So i tried an earlier version of EMC2 and it now runs ok, first one might have been a bad install. Got to admit was a little apprehensive about using it after trialing Mach3, but i now like it. Does what it says on the tin.

  4. #4
    You should have gone to radio rentals.....this is quite common but all the help you need is on the EMC2 site. Persevere with it as you will appreciate it in the long run
    http://wiki.linuxcnc.org/emcinfo.pl?..._missing_lapic
    If the nagging gets really bad......Get a bigger shed:naughty:

  5. #5
    Quote Originally Posted by 2e0poz View Post
    You should have gone to radio rentals.....this is quite common but all the help you need is on the EMC2 site. Persevere with it as you will appreciate it in the long run
    http://wiki.linuxcnc.org/emcinfo.pl?..._missing_lapic
    I did try that, but it still wouldn't run.

  6. #6
    That's a shame, i had similair prob on an earlier machine and it worked for me. I'm gad you have something working though, i much prefer it to M3
    If the nagging gets really bad......Get a bigger shed:naughty:

Similar Threads

  1. Help with Post Processor
    By superpot in forum CAD & CAM Software
    Replies: 0
    Last Post: 20-11-2013, 11:23 AM
  2. New post count bug?
    By irving2008 in forum General Discussion
    Replies: 0
    Last Post: 14-09-2012, 07:15 AM
  3. NEW MEMBER: First Post
    By Jumbo in forum New Member Introductions
    Replies: 3
    Last Post: 17-10-2011, 01:58 PM
  4. NEW MEMBER: Hello All, My First Post
    By Harvey Wallbanger in forum New Member Introductions
    Replies: 1
    Last Post: 11-06-2011, 10:05 PM
  5. NEW MEMBER: first post
    By makinswarf in forum New Member Introductions
    Replies: 3
    Last Post: 08-05-2009, 02:44 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •