Thread: Definately a scrapyard challenge
Threaded View
-
08-01-2012 #11
Problem with plagiarism is, as they always tell you at school, you copy other people's mistakes! I've put the ballscrew on the Y-axis of my machine in a sub-optimal position, which you've copied! It needs to be closer to cutter / between the rails. The problem is everything between the cutter and ballscrew can deflect, as the linear bearings don't offer much support in that direction. I posted more about it here:
http://www.mycncuk.com/forums/showth...h-X-and-Y-axis
(But don't start thinking of two ballscrews like I suggest there - it's excessive! Just put the ballnut on the other side.)
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
BUILD LOG: Scrap Heap Challenge
By TrickyCNC in forum DIY Router Build LogsReplies: 38Last Post: 16-09-2012, 07:52 AM -
NEW MEMBER: Up for a challenge......
By swatt in forum New Member IntroductionsReplies: 1Last Post: 03-10-2010, 10:57 PM -
Fancy a challenge?
By cassius in forum Machine DiscussionReplies: 5Last Post: 03-09-2010, 02:44 PM
Bookmarks