. .
Page 2 of 2 FirstFirst 12
  1. #11
    Quote Originally Posted by John S View Post
    Various people sell just a small charge pump board as an add on.

    http://www.cnc4pc.com/Store/osc/prod...products_id=51
    Artmin also spotted it shows how to set the charge pump inside EMC.

  2. #12
    Quote Originally Posted by JAZZCNC View Post
    Artmin also spotted it shows how to set the charge pump inside EMC.
    http://www.linuxcnc.org/docs/EMC2_Getting_Started.pdf Bottom of page 19

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 3
    Last Post: 18-05-2014, 03:40 AM
  2. Steppers, Series, Parallel
    By Ricardoco in forum Stepper & Servo Motors
    Replies: 14
    Last Post: 12-01-2013, 08:28 PM
  3. Parallel PCI Card Experience
    By andy0202 in forum Computer Hardware
    Replies: 11
    Last Post: 24-08-2012, 10:39 PM
  4. plan request connection card PCPPS
    By ali hedi in forum General Electronics
    Replies: 2
    Last Post: 07-04-2010, 08:18 PM
  5. Controller card selection
    By Hogout in forum Motor Drivers & Controllers
    Replies: 7
    Last Post: 14-05-2009, 11:26 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •