Thread: Newbie CNC Build
Threaded View
-
02-04-2012 #31
@JAZZCNC: OK, after a long busy week of research I could not come up with a better design that would meet my requirements so I am going to copy yours, if you don't mind of-course!
So I have gone and modified my last attempt to incorporate the adjazztability factor, This is what I have so far:
There is 1 thing that I am not sure about or if it even matters, is there any calculation for the length/angle of the diagonal supports that connect to the sides or is it just "Aim for the Middle area"?
Again, are there any obvious things I have missed here before I move on with the drawing?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
BUILD LOG: New Build - For Your Amusement - MK-2 build
By Karl in forum DIY Router Build LogsReplies: 12Last Post: 08-02-2017, 08:03 PM -
BUILD LOG: Newbie First Build 3000mm x 1500mm
By psiron in forum DIY Router Build LogsReplies: 16Last Post: 16-07-2010, 11:02 AM -
BUILD LOG: Newbie First Build
By Dr Snuggles in forum DIY Router Build LogsReplies: 0Last Post: 10-01-2010, 07:05 PM -
NEW MEMBER: Hi, from a newbie #2
By colonelrichard in forum New Member IntroductionsReplies: 2Last Post: 04-08-2009, 03:02 AM -
NEW MEMBER: Hi, from a newbie
By derekm in forum New Member IntroductionsReplies: 2Last Post: 03-08-2009, 06:45 PM
Bookmarks