Quote Originally Posted by Jonathan View Post
For the vast majority of machines 3.1Nm motors are a good choice. If the machine is small enough to use smaller motors its hardly worth it as the cost saving is so small. Unless it's a big machine (towards 8x4 size) 3.1Nm nema24's are good. What size is the machine?
not sur jonathon, think ive mentioned in earlier posts maybe 4 x4 to begin with... a starter... then progress... 4x6..what would be the limit ... could go 4.0nm but is that overkill.. mainly timber and mdf stock...


Can i just say this forum is awsome,,, so helpfull for us noobys so too speak not feeling like we are being talked down at by the people that know more than us... that has always been a pet hate of mine on some forums, infact when ive read some posts ive not even registered.. so thankyou all... especially jazz and jonathan..