1. #1
    Firstly I must apologize for taking to long to post my first post and say hello as a new memeber. I did not have CNC machine so was not very seriuos about CNC. I have purchased my first machine (TS-30408-H80 4 AXIS CNC ROUTER ENGRAVER), so now I would like to do somethink with it. I had a great difficulties to get 3 axis going because the manual I got wit the machine were in chines. I am going to have more dificulties to get the 4th axis going as I dont have a manual/instructions at all.Therefore I would be very greatfull if somebody could provide manual or any help with 4 axis.Thank you

  2. #2
    Hi Holic, No apology necessary, welcome to the site!

    Have you tried posting your question in somewhere like the "Mills, Routers, Lathes & Commercial Machines" forum? You might find someone there who can assist.

Similar Threads

  1. NEW MEMBER: Hi from QLD Australia
    By Gus in forum New Member Introductions
    Replies: 2
    Last Post: 06-10-2011, 05:04 PM
  2. NEW MEMBER: Hi from Australia
    By packmansdaddy in forum New Member Introductions
    Replies: 0
    Last Post: 05-06-2011, 10:36 PM
  3. NEW MEMBER: G'day from Australia
    By packmansdaddy in forum New Member Introductions
    Replies: 1
    Last Post: 15-02-2011, 05:06 AM
  4. NEW MEMBER: Hi from Australia
    By halfa in forum New Member Introductions
    Replies: 1
    Last Post: 17-12-2010, 03:43 PM
  5. NEW MEMBER: Hi from Australia
    By amcc in forum New Member Introductions
    Replies: 1
    Last Post: 12-09-2010, 10:29 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •