. .
Page 2 of 2 FirstFirst 12
  1. #11
    Or switch to LinuxCNC which is free but you will need to set up your whole machine again.
    If the nagging gets really bad......Get a bigger shed:naughty:

  2. #12
    all sorted, it was the licsense, thanks all....

  3. #13
    Quote Originally Posted by 2e0poz View Post
    Or switch to LinuxCNC which is free but you will need to set up your whole machine again.
    Only take 4 1/2 years....................................
    John S -

  4. #14
    Quote Originally Posted by John S View Post
    Only take 4 1/2 years....................................
    Is that from personal experience? That's not something I would be proud of.
    Old router build log here. New router build log here. Lathe build log here.
    Electric motorbike project here.

  5. #15
    LOL! i'm sure John could do it quicker than that
    If the nagging gets really bad......Get a bigger shed:naughty:

  6. #16
    Quote Originally Posted by Jonathan View Post
    Is that from personal experience? That's not something I would be proud of.
    I did nip down the pub for a pie and a pint in that time as well
    John S -

  7. #17
    Quote Originally Posted by John S View Post
    I did nip down the pub for a pie and a pint in that time as well
    I dread to think what state you were in after 4.5 years in the pub!
    Old router build log here. New router build log here. Lathe build log here.
    Electric motorbike project here.

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Some Gcode generating programs
    By Jonathan in forum Programmers Corner
    Replies: 20
    Last Post: 28-02-2014, 07:58 AM
  2. Help needed for a 3d part gcode for mach3
    By Rebekah_harper in forum Computer Software
    Replies: 33
    Last Post: 04-11-2013, 01:55 AM
  3. How to generate Lathe GCode from a drawing?
    By Robin2 in forum Computer Software
    Replies: 18
    Last Post: 25-10-2013, 04:04 PM
  4. Tapping Gcode
    By Kai in forum General Discussion
    Replies: 10
    Last Post: 14-12-2010, 07:07 PM
  5. PLease help - gcode newbie
    By scotty in forum Programmers Corner
    Replies: 3
    Last Post: 07-03-2010, 12:48 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •