DIY spindle design

[Scott]

anyone have videos of these diy spindles cutting aluminum ??

[blackburn mark]

anyone have videos of these diy spindles cutting aluminum ??

[HankMcSpank]

Hey Mark.....a very slick video - well done! I'm assuming that due to the amount of Bokeh you've played, that you used a DSLR?

Which editing package did you use?

[blackburn mark]

Hey Mark.....a very slick video - well done! I'm assuming that due to the amount of Bokeh you've played, that you used a DSLR?

Which editing package did you use?

7D (Boken city... got to love it)
Prem CS4 (bit twitchy but gets you there in the end)

[Scott]

thanks Mark just what i was looking for !!!! ( love the video ) WD40 mmmm lol

i have a 3040 router mill (chinese thing) thinking of upgrade the spindle its only got a 200w servomotor as a spindle could do with more grunt

[ChrisG]

Super video Mark,

[blackburn mark]

thanks Mark just what i was looking for !!!! ( love the video ) WD40 mmmm lol

i have a 3040 router mill (chinese thing) thinking of upgrade the spindle its only got a 200w servomotor as a spindle could do with more grunt

my large diy spindle motor will take 2000W, however, i run it on a 12v 350W power supply and have no issues with heat in the windings or speed controller getting silly.
with it being an outrunner it has good tourque compared with inrunner type spindles