1. #1
    Hi,


    I have some panasonic servo drivers model number MSDA043A1A


    I would like to wire them using a single phase supply, but from the model number I can tell these are meant for 3 phase supply. Panasonic tell me it is possible to use a single phase supply but will not tell me how to. I don't have the knowledge to work it out so I was interested to know if anyone has done this before and how do I go about it.


    I am in the UK and I have a 230-240v single phase supply.


    My servo has the connections L1, L2, L3 and ground.


    Many thanks


    Gav

  2. #2
    Try this link and see if it is the correct manual for the drive amp you have. http://industrial.panasonic.com/ww/i.../minas_a_e.pdf

    Page 22 gives you the connection options.

    Ian

  3. #3
    You could have a quick look inside the drive and see what L1,2,3 are connected to. If it's just a 3-phase rectifier then connecting single phase to any two of L1,2,3 will work, although you may have to de-rate it. That's how most VFDs are done.
    Old router build log here. New router build log here. Lathe build log here.
    Electric motorbike project here.

Similar Threads

  1. Replies: 19
    Last Post: 21-08-2013, 11:20 PM
  2. FOR SALE: Inverters 3.7Kw 3 phase
    By Ralph in forum Items For Sale
    Replies: 2
    Last Post: 28-07-2013, 03:03 PM
  3. convert 3 phase to single phase?
    By D-man in forum General Electronics
    Replies: 10
    Last Post: 06-04-2013, 12:16 AM
  4. Running a three phase router/mill on a generator?
    By gavztheouch in forum General Electronics
    Replies: 3
    Last Post: 19-02-2013, 12:39 PM
  5. Wiring 3 phase
    By Robin Hewitt in forum General Electronics
    Replies: 16
    Last Post: 10-07-2012, 11:07 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •