Hi all,

Ok, I'm hoping that Gary from Zapp will be able to answer this question......

As part of Zapp's driver kit1 you get a very simple breakout board. I never used it as I had an Optoport from DIYCNC. Now, I'd like to use it to build a control panel with various switches etc. but no matter how hard I try, the only pins I can get to be detected as inputs are pins 10,11,12,13,15. I've set Mach up to use pins 2-9 as input but they are not detected at all. Is there something special I have to do on this board to get the outputs to be inputs?

Regards, Jeff.