Geckodrives vs others

[andy0202]

It depends really on what size machine you're intending to use them on? Once that's known I can advise properly, but if it's a small machine you're unlikely to see the benefits.

Edit: Also did you have a particular Geckodrive in mind?

Thanks for the reply.

It will have a table of approximately 3ft x 4ft so I am considering 4Nm steppers paired with the geckodrive G213V which seems like it has been protected against almost everything so should last.

Nema23 Stepper Motor 4Nm x 3

G213V Selectable Resolution Digital Stepper Drive

I have looked at some of the leadshine drivers. Do they perform the same morphing as the geckos?

Regards
Andy