1. #1
    Hi All,
    Is it possible to use a button connected to an input pin to repeat the current loaded gcode in mach 3.
    I have looked through the oem lists for a trigger and tried various M and G codes but can't seem to get anything to work.

    Thanks in advance for any help

  2. #2
    Unless I'm missing something use g28 and g30 at the end of the code then press start button again ?
    John S -

  3. #3
    Working now thanks for the super quick reply.

Similar Threads

  1. Help needed for a 3d part gcode for mach3
    By Rebekah_harper in forum Computer Software
    Replies: 33
    Last Post: 04-11-2013, 01:55 AM
  2. Tile / Repeat G-Code?
    By Tenson in forum Programmers Corner
    Replies: 27
    Last Post: 23-09-2013, 08:17 PM
  3. Replies: 1
    Last Post: 20-10-2012, 02:50 PM
  4. wiring e-stop button
    By deannos in forum General Electronics
    Replies: 10
    Last Post: 14-01-2012, 11:03 AM
  5. Donate Button
    By Ricardoco in forum General Discussion
    Replies: 8
    Last Post: 08-09-2011, 10:32 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •