Thread: How to pre load screws
Threaded View
-
13-08-2012 #1
Hi i've been reading up a lot , and i've seen people say you need to pree-load the ballscrew and nut,, now me just been new to cnc and i'm planing to convert my viceroy tds11gb lathe to cnc, i do not no how to do this?
someone on an other forum said to get the c5 gear as its 0 back lash but on here and other places people say you have to pree-load the c7 to get 0 back lash?
could anyone tell me how to do this and if you have any photos could you put them up?
cheers
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Probably a stupid thought - VFDs, Transformer & switched load
By m_c in forum General ElectronicsReplies: 9Last Post: 17-09-2013, 10:45 AM -
Chip load chart
By motoxy in forum Machine DiscussionReplies: 1Last Post: 17-09-2012, 10:05 PM -
this site is taking a long time load or refresh pages
By deannos in forum General DiscussionReplies: 6Last Post: 15-12-2011, 10:00 PM -
ATX power supply - load resistor - do I need one ?
By rckeith in forum General ElectronicsReplies: 4Last Post: 18-08-2010, 03:21 PM
Bookmarks