. .
Page 3 of 3 FirstFirst 123
  1. #21
    Quote Originally Posted by CollinW View Post
    I'm looking for a good vinyl cutter and I haven't decided right now which would be the best for me.
    I will highly appreciate your input any tips ideas are welcome
    Since I posted about the plotter and knife, the plotter turned out to be worth a few bob, so I flogged it and bought a P-Cut 630
    vinyl cutter.
    I saw loads of things about P-cuts and people not being able to get them working, So I bought one very cheap cos the bloke couldn't
    get it to work!
    A lot of the software available is really grotty. I ended up with a copy of flexisign pro. I cut all the masks to paint the transfers on a
    few push bike frames, some of the lettering I cut was less than 2mm high, the cutter worked flawlessly. I didn't mess about, I did the
    drawings in illustrator and cut them with flexisign. I read something and the bloke was drawing in inkscape and cutting directly
    from inkscape.

  2. #22
    @Jonathan what kind of vinyl cutter did you use at school? Would you recommend it?
    Jonathan is not likely to answer as the post is 7 years old
    ..Clive
    The more you know, The better you know, How little you know

  3. #23
    And the 'Old Thread Revival Award' goes to ........
    A DEAD (in a ditch) STATESMAN
    I could not dig: I dared not rob:
    Therefore I lied to please the mob.
    Now all my lies are proved untrue
    And I must face the men I slew.
    What tale shall serve me here among
    Mine angry and defrauded young?
    from EPITAPHS OF BREXIT 2016 - ????

    Thanks to ― Rudyard Kipling 1865 - 1936

Page 3 of 3 FirstFirst 123

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Cable drag chain
    By birchy in forum General Electronics
    Replies: 9
    Last Post: 04-01-2014, 12:45 AM
  2. Introducing LIMAC knife cutting machine with vision system
    By therouterlady in forum Manufacturer News
    Replies: 1
    Last Post: 22-05-2013, 11:58 AM
  3. Drag Chains
    By Mad Professor in forum General Electronics
    Replies: 3
    Last Post: 30-04-2013, 11:23 PM
  4. Drag chains
    By jcb121 in forum General Discussion
    Replies: 4
    Last Post: 14-05-2012, 11:44 AM
  5. wiring for drag chains
    By johngoodrich in forum General Electronics
    Replies: 10
    Last Post: 09-02-2012, 08:44 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •