Drag Knife anyone?

[graffian]

I'm looking for a good vinyl cutter and I haven't decided right now which would be the best for me.
I will highly appreciate your input any tips ideas are welcome

Since I posted about the plotter and knife, the plotter turned out to be worth a few bob, so I flogged it and bought a P-Cut 630
vinyl cutter.
I saw loads of things about P-cuts and people not being able to get them working, So I bought one very cheap cos the bloke couldn't
get it to work!
A lot of the software available is really grotty. I ended up with a copy of flexisign pro. I cut all the masks to paint the transfers on a
few push bike frames, some of the lettering I cut was less than 2mm high, the cutter worked flawlessly. I didn't mess about, I did the
drawings in illustrator and cut them with flexisign. I read something and the bloke was drawing in inkscape and cutting directly
from inkscape.

[Clive S]

@Jonathan what kind of vinyl cutter did you use at school? Would you recommend it?

Jonathan is not likely to answer as the post is 7 years old

[cropwell]

And the 'Old Thread Revival Award' goes to ........