Thread: Hello everyone
-
22-08-2012 #11
-
22-08-2012 #12
Exactly ! 65 psi would be like an IED going off lol
-
23-08-2012 #13
Not sure how thick your resin is there, but a method I use when "painting" composites with resin, is to run a heat gun on low or hot hair dryer over the surface. It expands the gas in the bubble forcing it to rise and pop on the surface and gets rid of most of them and I get pretty good results this way. Of course adding heat normally speeds up curing so you do have to be a little carefully depending on how long you do it for.
-
23-08-2012 #14
-
23-08-2012 #15
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks