Centec 2 ballscrews

[jonnydeen]

cheers for the reply gary, i was looking at your Gten FSDD ballnuts but the links to the datasheets were only bringing me to the zapp home page


i recon its just a tough choice of whether to butcher components to fit cheaper ballscrews or to just splash out on the more expensive miniatures

any who...

i thought i would post some solidworks screen prints to better describe my predicament (i know you guys love a little bit of imagery )


the first two is the standard table and the third shows how much material would need to be removed just to fit a chopped up 1204 nut in





here we have a 1204 nut before and after 'modification'




just to show you the clearances involved




100 points to the first person who finds 3 issues with the screenprints!

[WandrinAndy]

100 points to the first person who finds 3 issues with the screenprints!

Have only found 1 issue with the screenprints... Albeit a very serious one...

Your time format displays as for example 3:43 PM when I thought the whole world had agreed to use the 24 hour format.... it should read 15:43 !

Lol

[jonnydeen]

Have only found 1 issue with the screenprints... Albeit a very serious one...

Your time format displays as for example 3:43 PM when I thought the whole world had agreed to use the 24 hour format.... it should read 15:43 !

Lol

lol now thats just nit-picking

the 3 issues are a little more difficult than that

do you honestly think i would give away 100 imaginary points that easily????