feedtrate on NCstudio for Artcam problem

[Fivetide]

So can anyone help with this problem?
I can’t work out what the federate should be set in NCstudio. Below are the machines stats :

Spindle spec:

• Spec: 65*210 mm (Diameter:65mm x Length:210mm)
• Power: 800W
• Voltage: 220V~250V
• Frequency: 400 Hz
• Speed: 8000-24000 R/min
• ER11 collet chuck

Stepper drivers:

• Input Voltage: 220V-240 V, 50/60HZ
• Output Voltage: 0-240 VAC
• Output Power: 1.5 KW
• Output Frequency: 0-400 Hz
• Output Current: 7.0 A
• Capacity: 2.8 KVA
• Overload Capacity: 10.5 (60s)(A)

Stepper Motors:

• Step Angle: 1.8 degree
• Voltage: 1.8V
• Current: 3.0A/phase
• Resistance: 0.50hm/phase
• Inductance: 1.8mH/phase
• Torque: >=450mN. m
• Number of wire leads: 4
• Length: 65 mm

The default seems to be set at 2200 in the picture its set to 600



If you open the parameters you can alter these as below on the fly, I cant work out what they mean by G01 G02 G03 and then the other G00?




My machine is rated at 4000 mm/min



And the artcam feedrate for the tool is 76 mm/min



You can also set them in the main parameters settings



The problem I have is when I run a job I have to lower the feed rate to 20% this cuts the correct width and length but 3 x’s to deep, I can’t seem to work out how to set up the G00 code etc to match the machine.