Threaded View
-
27-04-2014 #33
If it would fit inside the big Siemens CNC you could skim the plates like you did with the bed.
Or if you had a large flat surface you could turn the frame upside down, the plates would lie on the flat surface than put some epoxy putty on them before setting the frame on top, wait until set before inverting and bolting.Last edited by EddyCurrent; 27-04-2014 at 04:44 PM.
Spelling mistakes are not intentional, I only seem to see them some time after I've posted
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
BUILD LOG: New Build - For Your Amusement - MK-2 build
By Karl in forum DIY Router Build LogsReplies: 12Last Post: 08-02-2017, 08:03 PM
Bookmarks