Thread: Ello!

  1. #1
    Hi all have been in toolmaking on and off for the past 15 or so years. I am currently running a Mikron HSM300 and various hurco mills. Making electrodes and doing hard and pre-hard milling. At the moment I'm just getting my teeth into learning the electrode extraction side, of CimatronE. Also have a few years experience on Sodick wire edm and cnc sparkers.
    I'm fairly competent on NCG cam if anyone on here uses it.
    Hope I can help out here as much as I'm sure you'll help me.
    Thanks Oscar

  2. #2
    Greetings Oscar and welcome to MYCNCUK :).

Similar Threads

  1. NEW MEMBER: Ello from Hull
    By Kai in forum New Member Introductions
    Replies: 1
    Last Post: 31-10-2010, 05:40 PM
  2. NEW MEMBER: ello
    By zedwizz in forum New Member Introductions
    Replies: 14
    Last Post: 09-06-2010, 09:45 AM
  3. NEW MEMBER: 'Ello.
    By korky in forum New Member Introductions
    Replies: 7
    Last Post: 14-05-2009, 10:41 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts