Gents,

thanks to D-man (cheers buddy!) my project is moving along rather smoothly, but it seems like I haven't thought it all the way through. As I have a rather limited understanding of bearing mounts and alignment problems I thought I'd ask here, maybe someone can give some tips / suggestions (fingers crossed).

I'm trying to mount a 20mm shaft in a case which holds two bearings, as shown on the following picture:



I'm using tapered roller bearings, which look like this:



My initial though was mounting the bearings using the 'snug fit' approach ie. make a seat for the bearing (shown on the drawing above) and push it in a hole which is slightly smaller than the bearing diameter. The bearing is 12mm thick (on the outside, the middle part is 15.25mm) and 47mm dia, so I though of making a 12mm deep 'seat' and cutting it 46.9mm for a press fit. I'm using MDF so I'm hoping this will be possible, but I'm not so sure the bearing will be held properly in place. I know this depends heavily on the forces acting on the shaft itself and those will not be large as the whole mechanism will be hand driven. This means resistance easy to break by hand cranking the shaft without pulling muscles.

The shaft will need to align with a hole cutout in another part of the machine, which will be adjustable vertically, lets call it carriage. This carriage will move on rails using linear bearings, so it should be rather straight, but I need to make sure the shaft is parallel to the rails. The parts holding the bearings will be CNC machined, but I'm guessing I might end up with misalignment anyway. Both bearing holding plates are 90mm away, the MDF is 18mm thick, so all together the shaft is supported on a length of 116mm.

Third thing that I'm not so sure about is mounting the bearings on the shaft (which will be machined on a lathe with the help of another great forum member). I've bought a 300mm piece of 20mm dia aluminium rod simply to try how it fits in the bearings. Slides in quite nicely to my surprise, although that feeling quickly disappeared when I realised it will rotate freely in the bearing and I need a tight fit, so that the shaft rotates with the bearing rather than in it.

So to sum up this ridiculously long post, I have three questions:

1. is a press fit a good method of mounting the bearing in the MDF parts?

2. should I assume that the CNCed parts will be precise enough to hold both bearings and give me a straight shaft or are the chances of having a wonky shaft quite high?

3. what's the normal method of properly mounting bearings on a shaft without a press and heavy equipment? the shaft will be aluminium for the prototype.

Any suggestions and tips are more than appreciated.

Regards,
dsc.