Thread: 7' X 4' Combi
Threaded View
-
05-01-2013 #27
First V-Carve Output Simulation, using 8mm Endmill, It looks so simple when you look at this picture.... Well its not.. This is just the backplate from the Y-side.
I Used the Sketchup model just for dimensions, and re-drew the lot in V-Carve, none of this fancy importing stuff, it never goes right for me..
RickAlways bear in mind that your own resolution to succeed is more important than any other - Abe Lincoln
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks