Don't plunge into Ali it knocks hell out the machine and cutter.!!
Here's 2 bits of code to try using a spiral entry both same except ones conventional milling and the other Climb milling so you can see difference.!
cutting 50mm Dia circle, 3mm deep, 1mm Doc, 4mm S-flute cutter, 15000rpm, 800mm/min, 400mm/min spiral down. Z zero top of material.
Edit: Rapid height =10mm
Last edited by Lee Roberts; 20-12-2012 at 11:04 PM. Reason: moved post from another discussion, so cleaned this one up a little
By dudz in forum Programmers CornerReplies: 5Last Post: 22-06-2013, 10:21 PM
By CambiumMachines in forum Manufacturer NewsReplies: 0Last Post: 09-01-2013, 03:56 AM
By Richie in forum Wood Finishing Tips & TricksReplies: 15Last Post: 14-06-2012, 04:09 PM
By moose007 in forum Programmers CornerReplies: 4Last Post: 22-05-2009, 10:39 AM
By Lee Roberts in forum Programmers CornerReplies: 0Last Post: 14-10-2008, 01:30 AM