. .
  1. #1
    Don't plunge into Ali it knocks hell out the machine and cutter.!!

    Here's 2 bits of code to try using a spiral entry both same except ones conventional milling and the other Climb milling so you can see difference.!
    cutting 50mm Dia circle, 3mm deep, 1mm Doc, 4mm S-flute cutter, 15000rpm, 800mm/min, 400mm/min spiral down. Z zero top of material.

    Edit: Rapid height =10mm
    Attached Files Attached Files
    Last edited by Lee Roberts; 21-12-2012 at 12:04 AM. Reason: moved post from another discussion, so cleaned this one up a little

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Anyone got some 2.5D G-code please ?
    By dudz in forum Programmers Corner
    Replies: 5
    Last Post: 22-06-2013, 11:21 PM
  2. Cambium Code Web Tools – Parametric G-code Generation
    By CambiumMachines in forum Manufacturer News
    Replies: 0
    Last Post: 09-01-2013, 04:56 AM
  3. Pros and cons of climb milling in wood
    By Richie in forum Wood Finishing Tips & Tricks
    Replies: 15
    Last Post: 14-06-2012, 05:09 PM
  4. G Code help
    By moose007 in forum Programmers Corner
    Replies: 4
    Last Post: 22-05-2009, 11:39 AM
  5. G & M Code Tables for Milling
    By Lee Roberts in forum Programmers Corner
    Replies: 0
    Last Post: 14-10-2008, 02:30 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •