Can anyone tell me exactly what i need to create vacuum table on my hurco vmc1 using compressed air. Seen it used years ago but dont know the set up.h
Hi, I had a Phoenix Magnum router (sold by Denford before they made their own cnc). The system as I understand it, was the compressor air blows over a venturi
tube which is connected to the vacuum matrix. this did work fine for engraving(not that I did much as I did not get to grips with the Procad software), but I am not sure how good it would have been after sucking through a sacrificial mdf board.
A disadvantage was that it needed my noisy compressor running all the time. I personally think you would be better off using a vac pump.
I have just made a vac table from pvc, which works quite well, but I had hoped to do away with my original ally table, sadly this was not possible as it did not
stay flat enough and I have had to reinstate the original table and bolt the vac table to it, reducing what was already a very limited Z travel. A friend
machined the plastic for me (too big for my fixed gantry router), but cannot machine another in ally on his machine.
Good luck if you do go for the compressor system, but I would go for a vac pump. Regards, G.
The Following User Says Thank You to GEOFFREY For This Useful Post:
You'll need a very high CFM compressor a Vacuum generator (venturi) and a tank,vac gauge,vac switch etc.
Have a look here http://www.joewoodworker.com/veneeri...bleventuri.htm
But I agree with Geoff and go for the vac pump with a tank far far better and reliable.
Last edited by JAZZCNC; 23-12-2012 at 11:36 AM. Reason: wrong link
The Following User Says Thank You to JAZZCNC For This Useful Post:
Merry Christmas to you as well. Yeah, 50 HP worth of pumps sure makes things easy. ;) But you'd be surprised how often you wish for even more.
I have a small electric pump that I'll be using on my next machine. I'll be using it with no tank, with dedicated pods or fixtures.
While a tank can help with the fast hold down, you'll get a bit more vacuum with no tank, as you won't get the drop that you get when the switch cycles the pump on and off. I have a veneer press that uses two venturi pumps, and the switch allows about a 4"Hg drop before the pump comes back on. A tank works best when you have a very good seal, so that the pump rarely needs to run. If you have any leakage, I'd skip the tank.
Obviously sucking thru an mdf sacrificial sheet means some leakage all the time. I have divided my small bed (540x450) into two separate areas, each connected to a small (600W) 230 V vac pump plugged into sockets on the machine front. When ready to rout I simply flick the switches on then off again when finished.
This seemed to be the cheapest easiest option. G.
By Tenson in forum Machine DiscussionReplies: 44Last Post: 08-01-2014, 06:40 PM
By Minium in forum Milling Machines, Builds & ConversionsReplies: 13Last Post: 13-11-2012, 08:52 AM
By FlightCaseCo in forum Machine DiscussionReplies: 4Last Post: 16-01-2012, 05:56 PM
By FlightCaseCo in forum General DiscussionReplies: 1Last Post: 31-12-2011, 11:34 PM
By templecorran in forum Machine DiscussionReplies: 18Last Post: 09-11-2010, 11:11 PM