Page 2 of 2 FirstFirst 12
  1. #11
    Didn't get the chance to have another look at it today but will hopefully try again tomorrow, thanks for the suggestions so far.

  2. #12
    Quote Originally Posted by Jonathan View Post
    For the water cooled spindle you can set this to as low as you want, since the cooling effect of the water is the same regardless of speed. The spindle torque is practically zero below 3000rpm, so I recommend setting it to 50hz. .
    Thanks for saying that, I had wondered about going lower than 100Hz but was a bit scared to burn out the coils. :)

Page 2 of 2 FirstFirst 12

Similar Threads

  1. Chinese 300W DC spindle - is the spindle shaft grounded?
    By HankMcSpank in forum Spindles & Drive Motors
    Replies: 44
    Last Post: 26-11-2016, 07:25 PM
  2. Replies: 0
    Last Post: 13-11-2013, 07:50 PM
  3. Spindle lock mechanism for 2.2kW china spindle
    By Jonathan in forum Generic Chinese Spindles
    Replies: 8
    Last Post: 13-08-2012, 08:39 PM
  4. WANTED: Spindle holder for 1.5kw Chinese spindle.
    By jcb121 in forum Items Wanted
    Replies: 19
    Last Post: 14-10-2011, 02:07 PM
  5. DIY Spindle - What type of bearings are best suited for a spindle.
    By 8iggles in forum Spindles & Drive Motors
    Replies: 18
    Last Post: 09-02-2011, 10:15 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •