1. #1
    hi all is there any mach 3 help available, new to this software, and i am looking for someone to tutor me via remote access if possible using team viewer i know the series of videos and i have been watching them

    all help welcome

  2. #2
    I'm game but don't have team viewer. Also it's not a good idea to do this with Mach actually working the machine has the Networking could cause it to Hang.?

    Really there's not much to learning about Mach.? Mostly it's how to set it up correctly and ounce done then it just works with very little to do other than hit Cycle start.!!

  3. #3
    Quote Originally Posted by JAZZCNC View Post
    I'm game but don't have team viewer. Also it's not a good idea to do this with Mach actually working the machine has the Networking could cause it to Hang.?

    Really there's not much to learning about Mach.? Mostly it's how to set it up correctly and ounce done then it just works with very little to do other than hit Cycle start.!!
    hi jazz

    i have mach 3 installed but not config to a machine, yet

    all motors and electronics are on teh way by slow boat to Germany, i will be in touch once i get them set up on a test rig, if thats ok

    and jazz check out my build log

    advice need there

    by the way jazz i am about hr and a bit from you ?

    by the team viewer is free check the site, also its easier to use and does not kill bandwidth like vnc just dl and install for personal use

    i will be in touch
    richard armstrong

    building 8x4 cnc all rounder, 2nd build.... major headache....LOL

  4. #4
    No problem and your actually more like 45-50mins away.

    Link me the build thread and the software and I'll take a look.

    Great sir name by the Way.! . . . I have one just like it. . .Lol

  5. #5
    Quote Originally Posted by JAZZCNC View Post
    I'm game but don't have team viewer. Also it's not a good idea to do this with Mach actually working the machine has the Networking could cause it to Hang.?

    Really there's not much to learning about Mach.? Mostly it's how to set it up correctly and ounce done then it just works with very little to do other than hit Cycle start.!!

    http://www.mycncuk.com/forums/router...materials.html
    richard armstrong

    building 8x4 cnc all rounder, 2nd build.... major headache....LOL

Similar Threads

  1. HID interface for remote control of Mach3
    By Smiler in forum Electronic Project Building
    Replies: 0
    Last Post: 10-05-2009, 12:59 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •