Thread: Stepper motors - problem
Threaded View
-
07-02-2013 #1
Last Activity: 19 Hours Ago
I have had no problems with my 3 Stepper motors until now. The Z axis motor still goes good.
The X and Y axis motors are on ballscrews via belts an pulleys and have began to act strangely.
I had two fuses blow in my controller, then found the problem to be two fried IC drivers. So I have replaced these. Now the X axis motor hisses plus it moves only very slightly and judders alot when jogged. And the Y motor sounds rough although it does turn properly but vibrates the machine. I have changed no settings. I have played around with "motor Tuning" in Mach3 but I can find no better setting than what it was set at originally.Last edited by dudz; 07-02-2013 at 10:11 PM.
3 axis CNC/router / Alu profile frame....25mm Alu Cutting bed X=500mm Y=300mm Z=110mm.....Supported 25mm X rails ....Supported 20mm Y rails....Supported 20mm Z rails.....2.2kw Chinese WC spindle..... CSLAB CSMIO/IP-M 4-axis Ethernet Motion Controller....M542 Drivers..SY60STH86-3008BF Motors...running....Mach3 / Cambam / Emachineshop.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
FOR SALE: Stepper motors & more for sale
By andrewbond in forum Items For SaleReplies: 9Last Post: 17-08-2012, 01:25 PM -
Help with Stepper Motors
By Scott in forum Stepper & Servo MotorsReplies: 8Last Post: 04-04-2010, 02:35 PM -
rs stepper motors
By chaz@2b in forum Stepper & Servo MotorsReplies: 19Last Post: 06-08-2009, 11:05 PM -
Motors and Board? Problem.
By m.marino in forum General ElectronicsReplies: 7Last Post: 17-04-2009, 10:47 AM
Bookmarks