Thread: Cutter question

  1. #1

    I'm shaping some surfboard fins out of G10. Could someone advise me on what type of cutter to use?

    I have read that a single flute is the best option.

    Any help is much appreciated :)

  2. #2
    I made my self a G10 fin for windsurfer and used single flute Carbide bit for roughing, same bit I use for aluminium, and twin flute carbide ballnose for finish. Both easily handled and gave nice finish.
    This stuff is quite abrasive so if was cutting lots of it then think I'd look at the Diamond coated Micro grain Carbide which are better suited to composites has think it would workout cheaper in long run.?

  3. #3
    Thanks for the help Jazz.

    Much appreciated.

Similar Threads

  1. CNC hot wire cutter
    By Nstocks in forum Machine Discussion
    Replies: 0
    Last Post: 22-05-2014, 06:54 PM
  2. Skimming yer bed.... does anyone use a fly cutter?
    By HankMcSpank in forum Machine Discussion
    Replies: 5
    Last Post: 08-09-2013, 03:57 PM
  3. What wattage laser cutter question
    By Fivetide in forum Laser Machines & Building
    Replies: 9
    Last Post: 09-08-2013, 01:56 PM
  4. cutter for MDF
    By deannos in forum Tool & Tooling Technology
    Replies: 5
    Last Post: 16-10-2011, 08:33 PM
  5. 55 degree cutter
    By ptjw7uk in forum Tool & Tooling Technology
    Replies: 5
    Last Post: 08-06-2009, 09:48 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts