1. #1
    Hello


    Thank you for entering inmy post




    I will be veryappreciative if you may have a look at this program I made




    I did invent myself thisprogram with this drawing: (see attachments)




    I didn't want to use thelatest cycles that iTNC530 offer as I am quite sure I will not havethis version but some older-ones in the company where I will have myjob trial




    so that's why I did inventthat way to make the 15 holes in the center and I used polarcoordinates to make those 12 m6 holes on that circumference




    I ask you to payparticular attention on the parameters I used to make thatrectangular pocket about:


    allowance for side


    allowance for floor


    tool path overlap


    plunging depth




    At the end I did put acountersink to clean all the bevels that the mill leaves




    Any other suggestionaccording it will be very appreciative




    Thank you in advance foryour help
    Attached Thumbnails Attached Thumbnails Drawing Die 2 037.pdf  
    Attached Files Attached Files

  2. #2
    On the die drawing the program is not quite correct. After the Cycle Definitions you must use Cycle call not Call label. Also the M6 command (Tool Change) should go after the Tool Define.

  3. #3
    Quote Originally Posted by Peter Griffin View Post
    On the die drawing the program is not quite correct. After the Cycle Definitions you must use Cycle call not Call label. Also the M6 command (Tool Change) should go after the Tool Define.
    Ok I know about cycle call

    About the M6 command (Tool Change) after the Tool Define, not all the heidenhain software require it

    Thank you very much Peter Griffin

Similar Threads

  1. Replies: 12
    Last Post: 16-11-2015, 10:04 PM
  2. How do I program my TECO VFD? Help!!
    By ArdenHTF in forum General Discussion
    Replies: 10
    Last Post: 08-07-2011, 12:23 PM
  3. RFQ: Write a program for me - Steel Dies
    By p4tvw in forum Projects, Jobs & Requests
    Replies: 8
    Last Post: 29-05-2010, 11:55 PM
  4. Free CADCAM program
    By Smiler in forum Computer Software
    Replies: 3
    Last Post: 12-04-2009, 05:07 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •